RPRadPaul Prints

RadPaul workshop / Flight simulation

A cockpit.
Built by hand.

My custom flight simulator panel, inspired by the Garmin G1000 NXi and built for Microsoft Flight Simulator with MobiFlight.

RadPaul custom flight simulator panel

The build list

Parts, materials & tools.

Component links from my original build, gathered in one place. Check each listing’s specifications and availability before ordering.

As an Amazon Associate, I earn from qualifying purchases.

Controls that bring it together

Switches & rotary encoders.

Illuminated push buttons

The original build used small momentary LED switches. Use this specification when searching eBay or AliExpress:

6 x 6 x 7mm LED Illuminated Switch Momentary Push Button Tactile SPST Micro PCB

For the version 2 build, I specified five dual concentric rotary encoders from PropWash, with black knobs.

View the PropWash dual encoder kit ↗

The alternative dual rotary encoders in the parts list were fitted using glue. The photos below show the five-pack encoders and their pin layout.

On the pictured five-pack encoders, the two small inner pins handle the push button: one ground and one signal. Each three-pin row has its common connection in the middle, with A/B or A′/B′ on either side.

Workshop references

Connections, pins & drawings.

Original wiring references for the rocker switch, rotary encoders, and Arduino connections. Open the images at full size for a closer look.

Open the electrical drawing (PDF) ↗

From the workshop

Watch the project.

Keep exploring.

See my custom truck simulator controls, or browse more RadPaul projects.

Truck simulator projects →